![]() ![]() In Quadversity mode, use these connectors for additional antenna inputs. Passes the RF signal from Antenna A and Antenna B to one additional receiver. ![]() RF Connection for Antenna A and Antenna B. ⑪ Coaxial inputs from Antenna A and Antenna B Ground Lift: Lifts the ground from pin 1 of the XLR connector and the sleeve of the ¼" Audio Output.Mic/Line: Applies a 30 dB pad in mic position.⑨ Mic/Line Switch and Ground Lift Switch (one per channel) XLR Outputs 1 and 2 are disabled when AES3 is enabled. Output 3 and Output 4 carry AES3 signals when enabled. ⑧ Balanced XLR Audio Output (one per channel) Set to Term 75Ω when Thru connection is not used.Set to Thru when passing signal to additional components.This disables analog output on XLR Output 1 and XLR Output 2. Thru: Passes word clock signal to additional componentsĮnables AES3 output on Output 3 and Output 4.Input: Connect to an external word clock to resolve the AES3 digital output.Flashing: network link active, rate corresponds to traffic volume.Use IEC extension cables to loop power through multiple devices.įour Ethernet ports carry the following signals: ![]() Protects the AC power cascade from overloads. Turn to scroll through menu items or to edit a parameter value.Press to cancel changes and return to main menus. The buttons are named F1, F2, F3, F4 (from top to bottom) and illuminate to when editing options are available. Press to access editing and configuration options. The LED will turn red when the limiter is engaged.ĭisplays information for the selected channel. Red, yellow, and green LEDs indicate average and peak audio levels. Orange = Normal (-90 to -70 dBm in 5 dBm increments).Indicate the RF signal strength from the transmitter: ![]() Note: The receiver will not output audio unless one blue LED is illuminated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |